Exit jam codes the paper comes out 6 inches of exit unit and goes into jam any sugestions E020
Exit jam codes the paper comes out 6 inches of exit unit and goes into jam any sugestions E020
Last edited by simonsays; 10-25-2013 at 04:44 AM.
sensor! change it
MOVING SERVICE COMPANY LTD Emerald Buddha
Address: 202 Tran Hung Dao Q1 TP HCM VIỆT NAM
Expert: sales, leasing, salamanders provide copier parts warehouse.
Tour: board repair resource, sys board, main board, board scan ...
Expert: purchase, exchange, used copiers.
Tel: (08) 54041727 - 0938877144-0976583422 Mr. NGHIỆP
YM: tienphatngoc2011@yahoo.com / hoanphuc20033@yahoo.com
GM: vannghiep25@gmail.com
Westie: mayphotocopytienphatngoc.blogspot.com
Have you done a sensor check in the test mode. Have you looked at the actuator to see if that is ok?
It didn't say that I couldn't do it in the manual.
i had this the other day and it was the registration clutch. it was the first time i saw it ever do that amongst the myriad of other issues ive seen it do. when the jam occurs does the print shift? otherwise we have had the exit bushings seize up on several occasions. is there a bridge unit on there. we have also had the mylar on the bridge gate rise up a little in the center due to a molding dimple.
must have been i dont run into bad casstees that offend i was very suprised
Bookmarks