Hi,
I have a Toshiba e studio 2540C, I'm trying to get into service mode 08 and I get a display User Service and Password which I don't know the Password any help will be much appreciated.
Hi,
I have a Toshiba e studio 2540C, I'm trying to get into service mode 08 and I get a display User Service and Password which I don't know the Password any help will be much appreciated.
If there is no password, just press OK
Some days, it's just not worth chewing through the restraints
I tried that thanks it seemed to work. Usually for the other machines 690 resets back to default in simulation 08 this model does nothing when you do that. Do you know the factory default code?
by default from the factory it is blank.
I left it on test mode and pressed start button nothing happened
Hi.If you get completely stuck and can not obtain the service password, you can reset it via the following method.Hold down while starting the copier up.[4] + [8] + [9] + [POWER]This will reset the administrator password AND service password.Have fun
Remember you will lose all user data when this is done!
Hi I set hold down 08 when I restart it and it beeps and all. Then I get the service password which I hit enter and I get into the screen that says "Test Mode" 100% D but there is nothing else on the screen. Is there something I am doing wrong? I'm attaching a picture here of what I see.
2016-02-15_1448 - impactcolor's library
Hi I've tried going into service mode and after I get into Test Mode D nothing happens. I punched in a code and hit "Start" and nothing happens. The screen just stays on the same screen. Am I doing something wrong? I've entered the correct service code password.
Hi there,
Im in the same boat, except im working on a 4540c series, if you get an answer, could you let me know..jper34@gmail.com
jaime
Indep. Copier Svc
Bookmarks