replaced tray 1 paper feed assembly.
Any ideas?
it only codes out and jams e020 out of tray 1..
replaced tray 1 paper feed assembly.
Any ideas?
it only codes out and jams e020 out of tray 1..
Is the cassette programmed with the correct paper size?
I have not failed. I've just found 10,000 ways that won't work. ~Thomas Edison
I have not failed. I've just found 10,000 ways that won't work. ~Thomas Edison
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
http://www.justmanuals.com
Paul@justmanuals.com
The guide where the alignment and reg sensor sit can become worn and its hard to see. Had a similar problem with a customer doing a lot of A4-R through there. Give that guide and mylar at try
It didn't say that I couldn't do it in the manual.
i just had this problem the other day it's the cassette it self change the cassetee out and your problem will be gone garantee toshiba say there was a bad bach of cassettes . ive had the same issue on both 355 and 455 ever scinece we changed the cassetes we havent bee back science it's vey strange but the fix works. try it beleave me you will be amazed you dont normally see things like this but thats your problem. Ive even put the trays side by side and you cant see any difference but once you change it it will not jam anymore just try it and them then hank me
Agree with Michael, check reg sensor actuators for paper cuts & mylars.
Bookmarks