F106 e350 help

[Steve0]

hi every body

i have a e350 machine, today it don't run and appear F106 code.

Intravia book say “point and print partition problem”, but i don’t know how to do.. help me please.

thanks for all help me out of a difficulty.

[nilsonmorales]

i dont know but have the service manual just send me a email nilsonmorales@hotmail.com

[Mr Spock]

08-690-2 start will reformat the hard drive.
If it continues (or is a maxtor harddrive) then replace the drive and reload the firmware.

[decimal]

i had same problem but i can't reformat harddisk because mode 08 doesn't work , it display "WAIT" forever .When i reload firmware(i use USB) it does display number 0 (OS update) .What happen??

[Sbarro]

You have to read firmware update guide
In eBridge 1 machine (like 350/450) you have to load on pen
first only the XXX.rom file and load in "49" mode on the machine.
After OS update don't turn it off ,take out pen ,put rest of the files on it and stick it on machine USB port again and push START.
After succesfull update remember to initialize firmware (08-947)

[Steve0]

Thanks Mr. Spock,

It was maxtor, so I replaced hard drive.
It is working now.

Thak you all,

[decimal]

Hi Sbarro
I see .But even there is only ROM.bin on USB it also does display number 0 .I updated 1-6(HDD,UI.SYS.scan..) ok and only this SYS board was.
The other sys boards have been updated normaly .I know this SYS board has problem,i hope someone has exp. about it