No display, no panel response.
Power supply fan runs, hard drive runs, fuser heats up. No motors engage, scanner lamp doesn't come on, no network response, but network leds light up.
Checked fuses, swapped fuser, tried power on with doors open and hard drive disconnected, no change. Couldn't see anything obvious.
Customer stated they would have to reboot machine sometimes in the morning because the display wouldn't come on.
A couple of the control panel wires were flattened behind fax board, but still had insulation, I played with the harness a bit to see if the screen would flicker but didn't make a difference.
I'm going to try the harness and see if that is the culprit, but they didn't seem that bad.
Any other ideas?
Thanks
Bookmarks