I am getting an error code 449. Replaced the thermistors, reset 08400 many times, but still get error code. Any help appreciated. TY
Ron
Thanks: 0
Likes: 0
Dislikes: 0
I am getting an error code 449. Replaced the thermistors, reset 08400 many times, but still get error code. Any help appreciated. TY
Ron
Search C449 on this forum - you will find additional suggestions. One of them being to check the connectors etc. for bent / broken pins.
Read the other posts....have you tried all they suggest?
clean the IH coil contacts that contact the fuser
Power can do this. Get out your power quality analyzer. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Put new thermistors in; thermal fuses are good. TY for your suggestions. RonOriginally Posted by bigwul
Will try that. TY. Ron
Ok thanks. Ron
Also I found two of my customers plug there copier into a 15 amp outlet with an adapter.
"Broken again"
Heat roller was bad; replaced full fuser unit. TY Ron
Posting Permissions
Reply With Quote
Bookmarks