Thanks: 0
Likes: 0
Dislikes: 0
Switched to black and white in middle of color run then threw the code. Color has disappeared, black is fine.
05=390 all colors above 268. 04-270 test patterns are all blank. 08-573 to 576 0 except 575 cyan at 7. Swapped entire EPU and transfer belt assembly, no effect. Drum and dev units turning. Put a strip of tape on M charge corona, blank. Didn't try laser or logic PCB. Anybody else see this?
It sounds like you covered much of the logical choices. What's left? HVT, laser, LGC.
I would expect the laser to code, so I would start with the HVT or LGC. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Posting Permissions
Reply With Quote
Bookmarks