Hi guys,
Does anyone have an idea for this. I need the part # for a gear in the shaft of 127K52900. A drive motor for the registration assy (i guess).
Thanks
Hi guys,
Does anyone have an idea for this. I need the part # for a gear in the shaft of 127K52900. A drive motor for the registration assy (i guess).
Thanks
Hi My friend check here the part no , there two gears , count how many teeth does the gear you want have.
Item Part No. Description 1 - Front Frame (P/O PL 13.1 Item 1) 2 - Rear Frame (P/O PL 13.1 Item 1) 3 - Lower Chute (P/O PL 13.1 Item 1) 4 - Stopper Bracket (Not Spared) 5 059K54890 Registration Roll ( REP 13.4.1) 6 059K26170 Preregistration Roll 7 005E18530 Coupling 8 413W08350 Ball Bearing 9 007E78050 Gear (36T) 10 807E21230 Gear (21T) 11 809E41710 Tension Spring 12 809E52460 Tension Spring 13 - Shoulder Screw (P/O PL 13.1 Item 1) 14 - Registration Upper Chute (P/O PL 13.1 Item 1) 15 - Upper Cover (P/O PL 13.1 Item 1) 16 930W00212 Registration Sensor, Registration Skew Sensor 17 962K59830 Sensor Wire Harness 18 - Preregistration Upper Chute (P/O PL 13.1 Item 1) 19 127K52950 Registration Motor ( REP 13.4.2) 20 054K34450 Preregistration Upper Chute 21 - Resistor Chute (P/O PL 13.1 Item 1) 22 - Side Registration (P/O PL 13.1 Item 1) 23 038E31060 Paper Guide 24 130E94910 CIS Array 25 - Bracket (Not Spared) 26 960K29140 CIS Control PWB ( REP 13.4.3 , ADJ 2.6)
Thanks xtrain and mukasa... very helpful...
Hi guys,
Here is a photo of the parts i was referring. I'm not sure if i have described it correctly. But it is the motor at the back of the machine that drives the registration assembly.Teeth on the gear only count 19. Is this it -
807E21230 Gear?
Thanks
That is the Pre-Regisgration motor. To my knowledge you can not order just the gear. The part # for the Pre-Registration Motor is 068K56400.
I checked the parts list in my PWS and found Exok is right, the gear is part of the preregistration motor and is not spared separately. In the past, when I cannot find a gear like this, I take the old one to a machine shop and have it duplicated. Sometimes this is cheaper than finding the motor.
hello dear friend I would have the technical manual of the Xerox 4590/4110/4112 thank you in advance. here is my email fredonaldy@gmial.com
Only edoc format.
You need to have the pws software for use this manual.
stoadis@gmail.com if you want it.
Bookmarks