Xerox WorkCentre 7755 error 342-325 (342.325.00) Main Motor Failure

[Detonation]

Thanks, I will check and post back monday.

[Detonation]

xcopytech had the right solution, the black developer was jammed. Replaced with new and all is good now. Thanks everyone for the input!

[Bessnet]

xcopytech had the right solution, the black developer was jammed. Replaced with new and all is good now. Thanks everyone for the input!

Hello Guys,

Please help me in regards with above mentioned error codes first code is 342-325 then 394-322.
main motor is not rotation and machines is not rotating as usual, at starting bypas lifts up half and ibt unit lifts and stuck in half.

i have tried changing
1. main motor assembly.
2. black drum motor assembly.
3. black developer motor assembly.
4. waste toner assembly.
5. 2nd btr drawer complete assembly
6. all drum motor.
7. mcu pwb board

[rockdude]

Please re-read what "Xcopytech" said.

Check the "imaging units" or "Developers Drums" whatever you want to call them, and check for Frozen, Stuck, binding, etc.. and replace whatever ones are bad.

These are "consumables" !!

[Bessnet]

Please re-read what "Xcopytech" said.

Check the "imaging units" or "Developers Drums" whatever you want to call them, and check for Frozen, Stuck, binding, etc.. and replace whatever ones are bad.

These are "consumables" !!

I have a running machines xerox dc 252 with me so I have tried changed all four drums and four developer units from a running machines.
same problem Ibt unit and bypass tray lifts up half and then struck
machines is idle no sounds on any assembly (motor ) rotation

[Detonation]

Could maybe be a problem in the LVPS too? As pretty much all motors should be running on 24V?