PLease could someone explain where the transmission belt is on the Docucolor 240. Thanks.
PLease could someone explain where the transmission belt is on the Docucolor 240. Thanks.
when you open the front door, there are 3 drawers. the first is the developer-drum drawer. the second is the IBT assembly drawer, and the third (with a green lever) is the registration-2ndBTR-fuser drawer.
You will need to remove 2 screws on both ends of the 2nd drawer. make sure u unlatch the lever of the 1st drawer b4 pulling the 2nd & 3rd drawers in order to see the IBT assembly (on the 2nd drawer). Then you will find the IBT belt (black)
IBT_Assy.jpg
To be most understood
Hello all. I am extremely new to all this. We just recently got a DC 240. I got the 042-326 error this morning. After a ton of research, I finally have the IBT assy out. Where is the reflective strip located? I do not see it?
Do the following carefully:
Remove screws marked in red circles.
Take apart these parts.ibt.png
Turn Clockwise with 5.5 mm screwdriver ( blue square mark ) these release IBT
At the bottom of the IBT is the reflective square, you can replace it with reflective material or clean it.
Thanks for your reply. I will try this today!
I have the same error.
The information posted so far is very helpful, although I can't see how to extend the drawer out far enough to reach the rear handle of the IBT.
Please help.
Thanks
It's open
Can you please advise the location of the Sensor? The belt is out.
Thank you so much!
I am going to do this right now
Bookmarks