Xerox 550

[Jibes_Tech]

Pls help me on error 117-325, on Xerox 550 and CE is not coming up and the machine seems hanging?

[xcopytech]

There is no 117-325 error.
It could be 116-325.
Ess fan error

[Jake2o]

Can you post a picture of the error on screen?
Is it a black screen with red writing or the normal error screen with the error code in the corner?

[adriansto]

Pls help me on error 117-325, on Xerox 550 and CE is not coming up and the machine seems hanging?

Remove battery from ess nvm pwba for 2 minutes. Put it back and try again.
It is wonderful if you have a previously machine nvm's saving.
If so, try to restore it - dc351 and reload machine software.
If fault still exist after all, then you need to replace the ess nvm pwba module.

[mickey singh]

Dont remove battery, it will kill the metered pin and reset to default, it also kills the software on the pwb, you will most likely have to purchase a new nvm pwb

[Jibes_Tech]

Dont remove battery, it will kill the metered pin and reset to default, it also kills the software on the pwb, you will most likely have to purchase a new nvm pwb

Wat am I going to do cuz, i hav remove d battery and d time hav reset to 2050 and the error still remains and is not shut down again! Pls help me out!

[mickey singh]

Where abouts in london are you? Pm me your details and ill give you a call

[adriansto]

Wat am I going to do cuz, i hav remove d battery and d time hav reset to 2050 and the error still remains and is not shut down again! Pls help me out!

If you have same 117-325 error then you need to replace the ess nvm module.
The software is still into this module flash memory but the chip device is bad.
The error 117-325 point to the fact the electronic chip device is malfunctioning.
If another error is pop-up on the screen this can be a good thing.

[Jibes_Tech]

If you have same 117-325 error then you need to replace the ess nvm module.
The software is still into this module flash memory but the chip device is bad.
The error 117-325 point to the fact the electronic chip device is malfunctioning.
If another error is pop-up on the screen this can be a good thing.

I hav done dat, is showing error 124-315 pls Wat am I going to do next?

[adriansto]

I hav done dat, is showing error 124-315 pls Wat am I going to do next?

You need to do the gp4 procedure -serial number syncronization- using sys1 as the pwb with good data.
After that restart machine and check for others errors.