Error Xerox Nuvera 288

[assvlad]

Good day! The problem was discovered two months ago. The error window to replace weak batteries charge to NVM. The battery was changed to two boards NVM. The machine does not work. We ordered two boards NVM, we have changed. Nothing happened. Machine dead. Error PEM-22-3200, PEM-22-3155

[xtrain]

PEM 22-3200 shows your system software license has expired, FFPS or DocuSp controller.

[assvlad]

PEM 22-3200 shows your system software license has expired, FFPS or DocuSp controller.

PEM-22-3200 System communication problem is being detected

[xtrain]

PEM-22-3200 System communication problem is being detected

Yes, the rap reads system communication problem, but if you read further, it states that the system software license has expired and is the cause of pem-22-3200.

[assvlad]

Yes, the rap reads system communication problem, but if you read further, it states that the system software license has expired and is the cause of pem-22-3200.

License normal. The machine worked on her.

[adriansto]

License normal. The machine worked on her.

Be sure the internal ethernet cable is pluged in ERI_1 and the customer ethernet cable is pluged in ERI_0.
Also watch CR33 and CR70 leds on registration control pwb. These must flicker. If they stays on then the distribution cable may be defective.
I presume you have the machine service manual.

[assvlad]

Be sure the internal ethernet cable is pluged in ERI_1 and the customer ethernet cable is pluged in ERI_0.
Also watch CR33 and CR70 leds on registration control pwb. These must flicker. If they stays on then the distribution cable may be defective.
I presume you have the machine service manual.

Hello. Ethernet cable checked. Good. CR33 and CR70 no LEDs on the Board. The service manual I not have.

[assvlad]

Be sure the internal ethernet cable is pluged in ERI_1 and the customer ethernet cable is pluged in ERI_0.
Also watch CR33 and CR70 leds on registration control pwb. These must flicker. If they stays on then the distribution cable may be defective.
I presume you have the machine service manual.

20160802113831.jpg20160802113841.jpg20160802113851.jpgIMG_20160915_163906.jpgIMG_20160920_085355.jpg

[adriansto]

Wihtout service manual the better ideea is to place a call to xerox service.
It is not a easy to service machine.
cr33 & 70 is on REGISTRATION CONTROL electronic board.

[assvlad]

Wihtout service manual the better ideea is to place a call to xerox service.
It is not a easy to service machine.
cr33 & 70 is on REGISTRATION CONTROL electronic board.

Without service manual it's hard to do something.
IMG_20160920_114451.jpgREGISTRATION CONTROL electronic board it? I'm only on this Board found rc70! For this Board are burning red Leds CR-81-36V, CR32-24V, CR17-RESET, CR21-TERMINA TED.