Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
250+ Posts
- Rep Power
- 0
Ilimintion faul on xerox 3050
Hello what i must to solve this problem? Thanks in advance
-
Senior Tech
250+ Posts
- Rep Power
- 0
Re: Ilimintion faul on xerox 3050
The problem is that display says ilumination fault i need your help thanks
-
Senior Tech
100+ Posts
- Rep Power
- 28
Re: Ilimintion faul on xerox 3050
This could be caused by several things:
See attached pages from the manual for this problem. 3040_3050_Illumination Fault.pdf
Bad exposure lamp: This is the most frequent cause for this problem. As the lamp ages, the light output will drop. Once the output gets too low, the machine will declare a fault. If the lamp is bad, the edge of the lamp will be dark in color like typical florescent lamp as it ages.
Defective Illumination Sensor: The sensor is mounted in front of the lamp, facing the open slot in the lamp. You can try running the machine in diagnostics, and look at the output of the lamp displayed when running 0921-5. Sometimes, you can adjust the angle of the illumination sensor to maximize this output reading.
Defective Lamp Ballast Board: If the exposure lamp light level does not change as you change the Copy Lighter / Darker button, the lamp ballast may be bad.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks