Greetings,
I have a DocuColor 240 with error 077-909.
I have cleared the paper jam, checked the sensors, manually ran paper through, and rebooted both with and without the fuser loaded.
What else should I be looking for?
Thank you.
Greetings,
I have a DocuColor 240 with error 077-909.
I have cleared the paper jam, checked the sensors, manually ran paper through, and rebooted both with and without the fuser loaded.
What else should I be looking for?
Thank you.
077-909 RAP
BSD-ON:
One of the IOT sensors detected paper when power was turned on or when an interlock was
closed.
Initial Actions
Perform the following:
• Clear any paper jam.
• Switch the power off then on.
• Check if the Regi Sensor actuator is operating properly.
• Check for any light leaks.
• Check for a change or drop in the power voltage at the customer site.
Procedure
Execute DC330 [077-101 Regi Sensor]. Place paper in front of the Regi Sensor (PL 4.4). The
display changes.
Y N
Go to BSD 8.10 and check the Regi Sensor for a short circuit.
Replace the MCU PWB (PL 11.1).
- Regi sensor is lit. Figure out why.
Bookmarks