Thanks:
0
Likes:
0
Dislikes:
0
-
12-315 is stacker tray offset motor fault
-
Service Manager
250+ Posts
- Rep Power
- 37
P72 is unplugged!
P72 runs thgrough behind wall and we found it is unplugged - how do I get access back there?
-
Service Manager
250+ Posts
- Rep Power
- 37
P72 = dv driver looks like
and we got to remove dv unit to get at it I believe
can you either send me rap on dv unit removal or just tell me? then I tihnk we got it licked
thanks a bunch
-
Service Manager
250+ Posts
- Rep Power
- 37
P72 12-pin connector behind rear wall
I cannot see where this is supposed to plug in at all - any help/advice appreciated.
It is a white 12 pin connector with orange wires
-
-
Service Manager
250+ Posts
- Rep Power
- 37
where is ros
I assume that is the center board viewed from back - I do not see a connetor male that will fit it?
-
remove left side cover, maybe you will have to remove HCF if machine have it.
than you will se under developer assy, ROS.
On back side of ROS you should connect that P72
-
Service Manager
250+ Posts
- Rep Power
- 37
we already removed the hcf and panel
and it is extremely tight back there - cannot even get hand under-back there
need to remove dv unit - it comes out 4 inches and locks - will not slide out - what am I doing wrong trying to slide the dv unit to get it out of the way?
-
remove photoreceptor, remove toner bottle and then unplug one cable, big connector on developer assy
-
Service Manager
250+ Posts
- Rep Power
- 37
got p72 in place
now we are faulting to 09.370.00 and 09.304.00
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks