Xerox Colorqube 93-536-00

[LamsterPaul]

I will get the error 93-536-00 Upper umbilical is heating too slowly
on my colorqube 9301, I´ve check the Heating Temp. but the upper printheads, will not heat up, very well
I´ve allready Change the Marking unit heater PWB


is the Problem from the 2 lines from the Ink Reservoir to the upper heads ?
now I have order the 604K54972 Umbilical kit

any hints ?

thanks
Paul

[prismtech]

I've seen these things blowup a million different ways but "heating too slow" is a first.

Replace upper umbilical or tubes as you call them. Report back.

You could also call RJ at dotcomliquidations and he would selling you a whole marking unit for 150 used. Plus frieght. Say James from Canada sent you.

I don't replace any "tubes" or reservoirs any more I just slap in a different one complete. Too much of a time waster.

Sent from my SM-G903W using Tapatalk

[LamsterPaul]

The umbilical kit has solve the problem, looks like there was a hole inside,
i have also see some, leaking color on the lower printhead at the connector,
looks like, that i need to replace the printhead soon or the lower umbilical kit is also no bad
replacement

I've seen these things blowup a million different ways but "heating too slow" is a first.

Replace upper umbilical or tubes as you call them. Report back.

You could also call RJ at dotcomliquidations and he would selling you a whole marking unit for 150 used. Plus frieght. Say James from Canada sent you.

I don't replace any "tubes" or reservoirs any more I just slap in a different one complete. Too much of a time waster.

Sent from my SM-G903W using Tapatalk

[prismtech]

The umbilical kit has solve the problem, looks like there was a hole inside,
i have also see some, leaking color on the lower printhead at the connector,
looks like, that i need to replace the printhead soon or the lower umbilical kit is also no bad
replacement

If it's leaking at the connector it usually indicates the print head has been removed after initial install.

It's a 50/50 crap shoot as to whether a used head will reseal with the umbilical.

Sent from my SM-G903W using Tapatalk