Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: xerox 7132

  1. #1
    Senior Tech 100+ Posts
    Join Date
    Feb 2010
    Location
    Bamenda
    Posts
    163
    Rep Power
    0

    xerox 7132

    Xerox 7132 displayed 010-333 how can i clair it .and i have forgotten the password.


  2. #2
    Service Manager 1,000+ Posts
    xerox 7132

    adriansto's Avatar
    Join Date
    Nov 2007
    Location
    Somewhere in Europe near Black Sea
    Posts
    1,586
    Rep Power
    40

    Re: xerox 7132

    Quote Originally Posted by cliffhangers View Post
    Xerox 7132 displayed 010-333 how can i clair it .and i have forgotten the password.
    Fuser overheat in center
    Be sure the fuser is driven and rotate.
    Also can be a software problem.
    This code must be reset from service menu.
    What machine software ?


  3. #3
    Senior Tech 100+ Posts
    Join Date
    May 2015
    Location
    Kampala
    Posts
    144
    Rep Power
    7

    Re: xerox 7132

    Quote Originally Posted by adriansto View Post
    Fuser overheat in center
    Be sure the fuser is driven and rotate.
    Also can be a software problem.
    This code must be reset from service menu.
    What machine software ?

    • To clear this fault, first remove the cause, next clear the value of NVM [744-248] to "0", and then turn the power OFF then ON.
      The flag of NVM [744-248] indicates 0: Normal, 1: NCS-Center abnormal high temperature value, 2: STS-Rear abnormal high temperature value, and 3: NCS and STS high temperature error.

      Check whether foreign substances or paper is wound around the Heat Roll.


      Turn the power OFF, disconnect the Main LVPS connector P/J1 and P/J2.

      At the PWB, measure the resistance between P/J1-3 and P/J2-3/4.
      Is the resistance infinite? Yes No Unanswered
      Replace the Main LVPS ( PL 18.1)


      Replace the following parts in sequence: Replace the Fuser Assembly ( PL 7.1).

      • Check the sw version of the controller sw - reload Software ( GP 7)
      • Fuser Assembly ( PL 7.1)
      • MCU PWB ( PL 18.1)







    • When turning the power OFF, turn OFF the power switch first and then the main power switch.



Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here