good day, have a 700, 077-311 wont get past that, any suggestions? thanks
good day, have a 700, 077-311 wont get past that, any suggestions? thanks
Front door interlook or inverter nip release sensor PL10.6 item#14 or inboard plastic link from fuser decurler is broken or bad invertor release motor.
ok, thanks, will try one by one, amazing thing is sometimes i get this error, i would turn machine off, pull the whole fuser assembly out, with the 2nd btr and registration assembly and just push it back in and turn machine on and it clears, for some reason it wouldn't clear this time, and also, it mainly only happens if I have a jam or a next reason to open machine door when a job is running, when i close the door this pops up. Will let you know my findings. thanks
I presume you did checked to have clean contacts on fuser connector also backplane connector
Bookmarks