Thanks:
0
Likes:
0
Dislikes:
0
-
Xerox 7675 "UI/NC Cable failure
Hello All, Looked at all previous info on this situation and it didn't seem like a consensus had been formed yet. Mine is a xerox 7675 which says
Reset the machine
UI/NC interface Cable failure has occurred.
The Machine may have been powered
on to quickly.
Power OFF the machine
WAIT 2 MINUTES
Power ON the Machine.
This has not worked and I was hoping to get Clarification before proceeding to try Everything previously posted. The machine did sit at least 6mos before this attempted activation if that somehow makes a difference as one previous reply inquired about sit time. Any insight would be greatly appreciated. thanks
Last edited by shango215; 10-31-2017 at 08:21 AM.
Reason: correction
-
Re: Xerox 7675 "UI/NC Cable failure
Remove the usb cable and watch what message is poped by machine.
If the message is changed then you have a bad usb cable - it is not an ordinary one.
If the message is same then you need to check if net controller is booting ok.
-
Senior Tech
100+ Posts
- Rep Power
- 34
Re: Xerox 7675 "UI/NC Cable failure
run an Altboot through your PWS
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks