install / reload network controller software on xerox 5645

**Enzo** · 02-18-2018

Hello friends. I have a xerox 5645 where I have a printing problem. when I send a print of a file with many pages to the machine, after a few minutes the network controller restarts. I think it's a network controller problem. I proceeded to reload the software via altoboot but the problem is still there. I have replaced the ram memories, but the problem is still there. at this point I wanted to replace the hard drive. I bought a new, formatted hard drive with the same gigabytes as the xerox hard drive. I proceeded with the installation of the software (always via altoboot) but the hard disk is not recognized. how can I solve this problem? the NC software is 21.113.02.000

**sureshraidu** · 02-19-2018

Originally Posted by Enzo

Hello friends. I have a xerox 5645 where I have a printing problem. when I send a print of a file with many pages to the machine, after a few minutes the network controller restarts. I think it's a network controller problem. I proceeded to reload the software via altoboot but the problem is still there. I have replaced the ram memories, but the problem is still there. at this point I wanted to replace the hard drive. I bought a new, formatted hard drive with the same gigabytes as the xerox hard drive. I proceeded with the installation of the software (always via altoboot) but the hard disk is not recognized. how can I solve this problem? the NC software is 21.113.02.000

Try one more hdd.
80gb or 160 gb only Altboot is sufficient.

Sent from my F5122 using Tapatalk