Xerox Colorqube 9301 Error 089-520

[LamsterPaul]

have someone a hint where the fault was or knowing Issue, for the Error 89-520-00 Home Sensor Timeout RAP ?

DC625 Calibration also will not work
thanks
Paul

[Phil B.]

have someone a hint where the fault was or knowing Issue, for the Error 89-520-00 Home Sensor Timeout RAP ?

DC625 Calibration also will not work
thanks
Paul

of course the calibration won't pass .. you have an error ... that must be cleared first... hopefully you have the SM ( never go out on a xerox without one )

[LamsterPaul]

of course the calibration won't pass .. you have an error ... that must be cleared first... hopefully you have the SM ( never go out on a xerox without one )

Yep, has a service manual,
have working the process trough, but the error will still come back,I think the sensor or the unit was faulty, so i order a new one, and hope it will work

[prismtech]

have someone a hint where the fault was or knowing Issue, for the Error 89-520-00 Home Sensor Timeout RAP ?

DC625 Calibration also will not work
thanks
Paul

This is usually caused by paper dust clogging up the home sensor on the registration pre-heat assembly.

Clean the sensor.

If that doesn't work replace the entire regi assembly. Takes five minutes.

I have a whack of these used to swap in when they get dirty.

Cheap paper will cause this error within 20,000 copies.

[Odin]

Hi, I have a Xerox CQ 9303, the same problem appeared 89-520-00 Home Sensor Timeout RAP. I performed the DC330, both motors work well, when the shaft is turned manually, the sensor responds (HI (x), LOW (x)). But the problem does not disappear. I have SM Need help pls.

[LamsterPaul]

Hi, I replace the complete PreHeat Assembly (801K37710) and the fault was gone

[Odin]

Hi, I replace the complete PreHeat Assembly (801K37710) and the fault was gone

yes, of course, the problem should disappear after that
Maybe there is an option to repair this unit

[prismtech]

yes, of course, the problem should disappear after that
Maybe there is an option to repair this unit

You don't repair the registration assembly. You throw it out and get a new one.

Garbage is garbage, and these units get old and brittle. Sensor flag breaks off home drive gear, etc.

Toss it.

Sent from my SM-T530NU using Tapatalk

[Phil B.]

Hi, I have a Xerox CQ 9303, the same problem appeared 89-520-00 Home Sensor Timeout RAP. I performed the DC330, both motors work well, when the shaft is turned manually, the sensor responds (HI (x), LOW (x)). But the problem does not disappear. I have SM Need help pls.

you really should start a new thread.

[Odin]

Thanks to everyone, I will look for a replacement.