have someone a hint where the fault was or knowing Issue, for the Error 89-520-00 Home Sensor Timeout RAP ?
DC625 Calibration also will not work
thanks
Paul
have someone a hint where the fault was or knowing Issue, for the Error 89-520-00 Home Sensor Timeout RAP ?
DC625 Calibration also will not work
thanks
Paul
This is usually caused by paper dust clogging up the home sensor on the registration pre-heat assembly.
Clean the sensor.
If that doesn't work replace the entire regi assembly. Takes five minutes.
I have a whack of these used to swap in when they get dirty.
Cheap paper will cause this error within 20,000 copies.
Hi, I have a Xerox CQ 9303, the same problem appeared 89-520-00 Home Sensor Timeout RAP. I performed the DC330, both motors work well, when the shaft is turned manually, the sensor responds (HI (x), LOW (x)). But the problem does not disappear. I have SM Need help pls.
Hi, I replace the complete PreHeat Assembly (801K37710) and the fault was gone
Thanks to everyone, I will look for a replacement.
Bookmarks