hello everyone please i have a problem with a xerox 700 ON POWER STUK ON 3/6 HELP WILL BE GOOD
THANK YOU IN ADVANCE
hello everyone please i have a problem with a xerox 700 ON POWER STUK ON 3/6 HELP WILL BE GOOD
THANK YOU IN ADVANCE
If it wont get past 3 its a possible config mismatch, in particular if you just purchased it. Try booting with the finishing accessories disconnected. If this is effective note the serial #'s and I, or one of us can tell you where the problem is.
Hope this helps
try to power the xerox 700 with stop+3+power saver
if not try stop+4+power sever
if not replace the MCU
Bookmarks