CopyCentre C2128 with 10-505.00 and 4-562.00 in need of PWS TOOL.

[DelawareJim]

Hello, I'm a Konica Minolta tech trying to help a small church with a pretty old copier. 10-505.00 and 4-562.00 are showing as faults, also copier is not available and now warming up messages. I can easily replace the ITB but how do reset the code? I think I may need the PWS tool? Not sure, I am out of my wheelhouse on this one. Would appreciate any help. Thanks very much, Jim

[Mukasa]

Hello, I'm a Konica Minolta tech trying to help a small church with a pretty old copier. 10-505.00 and 4-562.00 are showing as faults, also copier is not available and now warming up messages. I can easily replace the ITB but how do reset the code? I think I may need the PWS tool? Not sure, I am out of my wheelhouse on this one. Would appreciate any help. Thanks very much, Jim

Hi
Can try this if it can help

The IBT Home Sensor does not detect the Belt Home signal.
NOTE:
If this fault is declared 3 times in succession, print mode will be disabled. In order to clear this condition, reset NVM location IOT/Finisher 1221 to 0 in dC131.




Check the following:

• If the fault occurs immediately after installation, ensure that the IBT shipping brackets on the left side of the IBT Assembly have been removed.
  
• Check that the IBT Belt Cleaner is not damaged, binding, or incorrectly assembled.
  
• Ensure that the Transfer Belt is clean, free from damage, and that the Home position reflector is intact.
  
  
  (Changed IOT/FINISHER nvm 1221 from 3 to 0.Machine started working)
  

[xcopytech]

You can not do anything without pws and diagnostic software for wc2128