XEROX WC5330

[zaza]

Hello everyone we have error code 061-320 . xerox wc5330 ..pls any idea ?

[Mukasa]

Hello everyone we have error code 061-320 . xerox wc5330 ..pls any idea ?

Hello Zaza ,
When does this code come on , when warming up or when you press start to print.
These fault code is about the ROS Motor.

• The ROS Motor rotation speed does not reach the specified value within the specified time after the ROS Motor started rotating.
  
• The light intensity of the LD1 does not reach the specified value.

Procedure

Check the connections of P/J406 on the MCU PWB and P/J140 on the ROS Unit.
Connections are connected correctly. Yes No Unanswered
Connect P/J406 and P/J140.



Check the connections of P/J160 and P/J170.
P/J160 and P/J170 are connected correctly.Yes No Unanswered

Connect P/J160 and P/J170.


Check the wire between J406 and J140 for an open circuit or a short circuit (BSD 6.4 Flag 1/ Flag 2).
The wire between J406 and J140 is conducting without an open circuit or a short circuit. Yes No Unanswered
Repair the open circuit or short circuit.


Check the wire between J406 and J130 for an open circuit or a short circuit (BSD 6.5 Flag 1).
The wire between J406 and J130 is conducting without an open circuit or a short circuit. Yes No Unanswered
Repair the open circuit or short circuit.


Execute Component Control[061-200 ROS MOTOR ON].
The ROS Motor can be heard. Yes No Unanswered
Measure the voltage between the MCU PWB P406-10 (+) and GND (-) (BSD 6.5 Flag 2).
The voltage is +24VDC. Yes No Unanswered
Measure the voltage between the MCU PWB P400-1 (+) and GND (-) (BSD 1.2 Flag 1).
The voltage is +24VDC. Yes No Unanswered
Measure the voltage between the Power Unit P526-4 (+) and GND (-) (BSD 1.2 Flag 1).
The voltage is +24VDC. Yes No Unanswered
Replace the Power Unit ( PL 9.1).


Repair the open circuit between J526 and J400.


Replace the MCU PWB ( PL 9.1).



Replace the ROS Unit ( PL 3.1) If the problem persists, replace the MCU PWB ( PL 9.1).


Install the Xero/Developer Cartridge securely.
Measure the voltage between the MCU PWB P406-2 (+) and GND (-) (BSD 6.4 Flag 3).
The voltage is +5VDC. Yes No Unanswered
Replace the MCU PWB ( PL 9.1).


Replace the ROS Unit ( PL 3.1) If the problem persists, replace the MCU PWB ( PL 9.1).