xerox 8870 printhead

[propthy]

Hello

i own xerox colorqube 8870 with 77.000 prints so far. Unfortunately some cyan jets are missing and cleaning routines plus jet substitution cant help the issue.
Xerox support inspected the printer and they offered a fix of 2.300 euros. There is no reason for my to pay this amount and i read that if i remove the print head
and warm it up with a drier the stuck ink will melt and the print head will work with all its jets. The problem is that i do not know how to remove the print head.

can you post a video or a step by step guide to remove it please ?

thank you in advance

[Phil B.]

Hello
own xerox colorqube 8870 with 77.000 prints so far. Unfortunately some cyan jets are missing and cleaning routines plus jet substitution cant help the issue.
Xerox support inspected the printer and they offered a fix of 2.300 euros. There is no reason for my to pay this amount and i read that if i remove the print head
and warm it up with a drier the stuck ink will melt and the print head will work with all its jets. The problem is that i do not know how to remove the print head.
can you post a video or a step by step guide to remove it please ?
thank you in advance

Dude those Color cubes can be a BITCH for even a Certified Tech that started off with the old phaser series!!!
and for a NON certified tech (never mind END USER)
Whiskey Tango Foxtrot ????

frankly I wouldn't fuck with it your self...

2,300 euros that sounds like new wiper assm... new printhead and HOURS of labor.

torx drivers... vaccum gauges .. PWS and Edoc needed among other basis tools...

are you equipped?

GOOD set of torx driver bits 35$ usd Gauges -= only from XEROX in training kit =- $???? ..PWS 500-800$ usd Edoc you might talk someone out of here.. but with out PWS.. your pissing in the wind. How many of the basic tools do you have? Spring hooks - forceps - MM ruler - screw drivers - Philips and ASE ..

MIND YOU.. if you get in there and find ink spilled all under printhead onto boards.. ETC the bill will be more and YOU don't have access to NEW ( not pulls nor refurb ) boards

sensors could be fucked..

BESIDES ALL THAT.. you never stated AN ERROR Code associated to the problem.

[propthy]

hello

there is no error code just not good prints

[Phil B.]

hello there is no error code just not good prints

IF you ran the smears/missing jet menu ... like you said * there WOULD be * error code/message...

clearly you don't even know to properly operate your machine...


I'm done.

[propthy]

sorry there is not error message

im not a professional

[Phil B.]

sorry there is not error message

im not a professional

then hire one ... You are -=way=- outta your league on this one!

[propthy]

Hello Philip

since xerox is expensive and i do not have the knowledge i will seek a specialist in Google, one last question though

if you blow the printhead with warm air will it get fixed ? because if i need a new printhead anyway there is no point to find the specialist

the cost is high

thank you

[Detonation]

The ColorQubes are very different from the laser/LED machines, but frankly removing the print head is not that hard. Haven't searched myself, but I bet there are YouTube videos. I do however sincerely doubt you can recover the ink jets by anything else but the built-in diagnostics routines.

[propthy]

Hello

i have tried built-in diagnostics routines without success and honesty i haven't found a single video in youtube

[OMG]

You don't need any special tools. Just the correct size torque wrench

Here's a video. Different model but basically the same procedure.

YouTube

Using a hair dryer ain't gonna fix it.