Originally Posted by
makutzi
OK found the codes i wanted: did the following checks and all worked out fine and no noise from them:
042-200 ITB belt home sensor (low)
010-010 Fusing motor - perfect
042-001 Main motor - perfect
042-005 Drum motor K - perfect
042-009 Drum motor CMY - perfect
042-013 ITB Drive motor - perfect
So the grinding noise is still there. As mentioned at about the half height of the machine at the back. Sounds like gears slipping or a belt. The sounds comes on shortly after startup for a bit (its not the duplexer - which is at the front) and then when I print it starts and stops short of the paper coming out of the machine. On continous prints it is there all the time, and sometimes it is only there every now and then.
Bookmarks