Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. #1
    Junior Member
    Join Date
    Mar 2008
    Posts
    8
    Rep Power
    0

    xerox workcentre 7132 with ERR code 010-330

    Hi , I have workcentre 7132 with err 010- 330
    How I can to fix this ERR plz,
    regard,

  2. #2
    Trusted Tech 50+ Posts
    Join Date
    Aug 2008
    Posts
    67
    Rep Power
    32
    Quote Originally Posted by na5_70 View Post
    Hi , I have workcentre 7132 with err 010- 330
    How I can to fix this ERR plz,
    regard,
    Hope this Helps

    010-330 Fuser Motor Failure RAP
    BSD-ON:4.1B
    The Fuser Motor is not rotating at the specified speed.
    Initial Actions
    •Power OFF/ON
    •Reload the Xero/Developer Cartridge (PL 4.1) and the Fuser Unit (PL 7.1).
    Procedure
    Close the LH Cover and the Front Cover.
    Execute Component Control [010-001 Fuser Motor ON].
    The Fuser Motor can be heard.
    YN
    Go to the OF 4 (Fuser Drive Assy RAP).
    Check the installation of the Fuser Unit (PL 1.1).
    The Fuser Drive Assembly is installed correctly.
    YN
    Install the Main Drive Assembly correctly.
    Check the wire between P/J412 and P/J226 for an open circuit or a short circuit (BSD 4.1A).
    The wires are conducting without an open circuit or a short circuit.
    YN
    Repair the open circuit or short circuit.
    Manually rotate the Fuser Motor rotor.
    It rotates smoothly.
    YN
    Check for foreign substances that are interfering with operation or installation failure.
    Foreign substances or installation failure are found.
    YN
    Replace the Fuser Unit (PL 7.1).
    Remove the foreign substances that are interfering with operation and correct the installation failure.
    Replace the Fuser Unit (PL 7.1) If the problem persists, replace the MCU PWB (PL 11.1).



  3. #3
    Senior Tech 100+ Posts
    Join Date
    Mar 2009
    Location
    lahore , punjab
    Posts
    232
    Rep Power
    0
    enter the diagnostic mode with hold the 0 key for 4 sec and then press the start key. 6789 is password go to nvm read write and reset the velue at nvm location 744- 004 to 0 .

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here