Hi everybody,
I have a Xerox 7132 giving me an error code 010-333, I already replace the fuser with a fuser from another machine and I reset the fuser under supplies, but I'm still getting the code.
I really need some help.
Thanks.
Hi everybody,
I have a Xerox 7132 giving me an error code 010-333, I already replace the fuser with a fuser from another machine and I reset the fuser under supplies, but I'm still getting the code.
I really need some help.
Thanks.
Thanks for your reply.
I already check that and is set to zero (0) and I also change the fuser with a fuser from another machine that was working and I still have the same code.
The code is still there.
Please help, I've been dealing with this for over a week.
Thanks.
- Follow 010-333 Fuser Center Thermistor Overtemp RAPfirst to check all elements without replacing parts at this point if not needed.
- Check NVM location 744-004. If value is different than 0 (like a 3), set it back to 0.
- Before replacing any parts; Insure that the NVM sheet is present and filled. Initialise the MCU Section 6 / Diagnostics (Others) Initialize NVM, select IOT.
- If problem comes back, per Note in the RAP replace Fuser Assembly PL 7.1 item 10.
- Per RAP, If the problem persists, replace the Power Unit PL 11.1 item 7. If the problem persists, replace the MCU PWB PL 11.1 item 22.
- Access Diagnostic Routines.
<LI id=svc.elan.0000097953>Enter UI Diagnostics (Entering UI Diagnostics in UI Diagnostic Mode).- Access Diagnostic Routines (Accessing Diagnostic Routines in UI Diagnostic Mode).
<LI id=svc.elan.0000038408>Select Maintenance/Diagnostics.
<LI id=svc.elan.0000038412>Select Initialize NVM.
<LI id=svc.elan.0000038421>Select the desired item, then press the Start button.- After initialization is complete, use the data accumulated in Initial Actions to restore the machine to its previous configuration
See Attached File
What is NVM? where can I locate that?
I have the same problem and I'm hoping I can solve this by setting the NVM to 0.
Thank you.
Replace the fuser unit with a NEW (now used) and reset nvm 744-004 to 0. Some xerox machines don't clear fuser error codes without replacing the fuser with a new unit. If problem still persists, then it could be a faulty low voltage power supply (LVPS) which means, you need a xerox tech to fix it
FIRST CHECK THE VOLAGE SUPPLIES FROM THE LVPS YOU MUST FIND 220V OR 110V IN THE PIN J5-3 AND J5-4 IN LVPS, IF YOU WILL NOT FIND THIS VOLTAGE REMPLACE LVPS
IF THE VOLTAGE FOND ? CHECK THE VOLTAGE FROM THE FUSER CONNECTOR YOU MEST FIND 22V IN TNE PIN 3 AND 6 IF YOU WILL NOT FIND THE VOLTAGE VERIFIE an open circuit or a short circuit FROM THE LVPS TO FUSER CONNECTOR IF ALL DOES OK REMPLACE MCU PWB
am also having that same problem but i dont know how to clear the error code and how to get to the nvm please can anyone teach me that please
Bookmarks