HI,
I have a problem with my photocopier/printer. It dispalyas the error code 092-310 and will not function. I believe this error to relate to the adc sensor but cannot find it!
Can anyone help?
Regards
Kenny
HI,
I have a problem with my photocopier/printer. It dispalyas the error code 092-310 and will not function. I believe this error to relate to the adc sensor but cannot find it!
Can anyone help?
Regards
Kenny
please see below procedure i hope it will help you.
There is a failure in the ADC Sensor circuit.
[IMG]pws://file/xerox/edoc/wc7132/icons/arrwup.gif[/IMG]Procedure
Enter NVM Read Write location [752-007] and check the value.
The value is within operating range. Yes No Unanswered
Verify the condition of the circuit between the ADC Sensor and MCU PWB.
The circuit is free of damage. Yes No Unanswered
Repair the circuit as required.
Check the operating voltages between the ADC Sensor and the MCU PWB.
The voltages are correct. Yes No Unanswered
Replace the MCU PWB ( PL 11.1).
Replace the Sensor Bar Assembly ( PL 11.1).
Replace the MCU PWB ( PL 11.1).
after inisialising NVM value, make copy in black mode and check quality, if the quality copy is not good donc you have a probleme with black developer housing causing by the brush was sparse on the magnetic roller. Subsequently, it was found that the screws holding the trimmer bar in place in these developer housings were rotated relative to their initial position.
you can fixe the screws or change the developer housing
there is a new part list for developer housing solve this probleme
<FONT face="Arial Black">
K: 604K42980 (Developer housing) 675K38910 (Developer Material)<SPAN style="FONT-SIZE: 10pt; COLOR: blue; FONT-FAMILY: Arial; mso-fareast-font-family: 'Times New Roman'; mso-bidi-font-family: 'Times New Roman'; mso-fareast-language: EN-US; mso-bidi-font-weight: bold">
Where exactly is the ADC Sensor circuit and the MCU PWB? and how can I "Enter NVM Read Write location [752-007] and check the value.
The value is within operating range. Yes No Unanswered
Verify the condition of the circuit between the ADC Sensor and MCU PWB.
The circuit is free of damage. Yes No Unanswered
Repair the circuit as required" cause it keeps displaying 092-310 and wont let any of the buttons function.
hi
first you have to check the all developer contains, if any developer is low replace it.
check ADC values in PRO-CON test.(if u have had any idea about ADC values here u can identify the problem by seeing these values)
second clean ADC sensor bar.
third check the patch on IBT,if it is not good clean IBT belt.
Fourth check developer module caps. if it is not their replace it.(If it is not their tonner will not pump into the module)
fifth cross check MCU.(some times if we replace MCU it will reset all NVM values)
Only 3.5 years too late....
Bookmarks