xerox 8830

[AUS XEROID]

First power on controller, wait some time, then scanner and then printer.

If your controller is N5T, you should know which firmware version is installed on it.

if version is 5.99 (from Pc which is connected to machine through network cable in web browser enter ip address of machine, then you will be able to get info from controller) you will be able to reload firmware and to keep all aditional functions such scanner.

if version is higher after firmware upload your machine will be just copier, printer.

To resolve your problem must reload firmware to controller, there is procedure and firmware on xerox web site

Power scanner on first then controller when you see "SE: ok" on the scanner if it's a SynScan scanner, Or when the lamp comes on if it's a 7356.

[davidj7]

E701 .Any suggestions?

I took another N5T and hooked it with the same scanner and printer, it worked fine and i got the test page.

When i connect the original N5T , I get E701 which according to RAP is communication error. So I have ruled out cable fault, scanner/printer fault.
Now if its Accxess controller System software . I have the restoration files , to restore via XesSend , but I dont know how to do it.Could someone guide me through the process. To execute the N5T batch file it needs the IP address I have no idea what the IP address is.

Could there be another fault besides accxess controller software?

[TzALbg]

maybe interface PWB SCSI on N5T is blown

[copytech200X]

i had same fault code E701 communication error ..i replaced hard disk then ok

[davidj7]

i removed the Hard Disk from the working N5T controller and fixed it into the Non working N5T. No change , E701. So its not Hard Disk Problem.

SCSI PWB I will check

How do I restore the system software via XeSSEND.

[copytech200X]

problem lies at the N5T controller ..

[davidj7]

yes i know problem lies with N5T, any suggestions on where to look for a fix?

[XeroxTechBrazil]

You have the controller service manual, right?

[davidj7]

yes techbrazil i have manual but not making any headway :-(

[xcopytech]

when power on controller and 8830 watch on 10 red leds (on controller main board), and see which leds stay on.