Xerox 116-330

[copytech200X]

format hdd under low level format and turn on machine press 4 + stop +power save . Active@ Kill Disk Hard Drive Eraser. Low Level Format. freeware ..do not do any partition at windows or make it active.(just plug in to machine and press 4 +stop + power save)jot down customer network setting eg: ip,subnet and gate add before perfomed hard disk initialize.

[jagomez]

I have 2 HDD units, one equal that the original a Toshiba 20GB and other Samsung 160GB.
I format the hdd in low level and connect to the copier, press 4+stop+powersave and report the same error code 116-330.
With the hdd original connected reports error code 116-201 and this hdd in windows isn't run, is broken.
I deduce, the hdd is broken and another device or board are broken to.

Any idea to check anythink? thanks

[copytech200X]

I have 2 HDD units, one equal that the original a Toshiba 20GB and other Samsung 160GB.
I format the hdd in low level and connect to the copier, press 4+stop+powersave and report the same error code 116-330.
With the hdd original connected reports error code 116-201 and this hdd in windows isn't run, is broken.
I deduce, the hdd is broken and another device or board are broken to.

Any idea to check anythink? thanks

u can try install your hdd at running condition machine and do 4+stop+power save then after "ready to copy" reinstall hdd to ur machine.

[jagomez]

install your hdd at running condition machine

I don't understand, Would you say to Connect the hdd unit to the machine later power on? Is dangerous

The copier doesn't run without hdd, reports the same error code 116-330.

what steps I can do to make it?

[copytech200X]

I don't understand, Would you say to Connect the hdd unit to the machine later power on? Is dangerous

The copier doesn't run without hdd, reports the same error code 116-330.

what steps I can do to make it?

i mean find one running condition machine to do format ..ok

[widewings]

how do you do a format from a working machine on the new hard drive? cheers.

[johnner66]

what i did is take one workable hd from working m/c n copy the data from the disk to the new one then put to m/c it work fine for all my problem 116-330/116-321 good luck

[copytech200X]

how do you do a format from a working machine on the new hard drive? cheers.

to format new hdd press 4+stop+power save this code is hard disk initialise ...or connect pws and run hdd diag.

[widewings]

to format new hdd press 4+stop+power save this code is hard disk initialise ...or connect pws and run hdd diag.

hi, I did that but it just rebooted again then I still got the same error 116-330.

By the way, what is "pws"? And how can I run hdd diag. Thanks.

[copytech200X]

PWS=portable workstation station is a system software to connect xerox machine with serial cable.