I have a problem with the margins. the copy goes out moved of 5 millimeters in comparison to the original one. how can I resolve this problem? which is the formulation in the menu of system? Thanks.
I have a problem with the margins. the copy goes out moved of 5 millimeters in comparison to the original one. how can I resolve this problem? which is the formulation in the menu of system? Thanks.
Perform system registration setup
I have only modified the value of "20-1 lead registration" and I have resolved the problem. thank you so much!
the same problem reappears me! would someone know to tell me which the values of default of the codes are 6-80=side registration (600dpi) all trays and 20-1 = paper feed lead edge registration adjustment? and then I would like to know what the parameter is to modify for moving aloft the edge from ADF. practically when I serve some copies as the adf, the edge is moved me quite a lot in low. thanks.
to adjust dadf lead registration you have to modify page 21-80 and to modify platen lead edge 21-71
I think you should clean or replace registration clutch. Adjusting registration in diagnostic won't help you.
Bookmarks