Hi everybody,
Im looking for help with a Xerox WC Pro 35, I have an error code 0956-00-00 and have not been able to find out what it means.
Any help would be greatly appreciated, service manual, anything.
Thanks in advance.
Hi everybody,
Im looking for help with a Xerox WC Pro 35, I have an error code 0956-00-00 and have not been able to find out what it means.
Any help would be greatly appreciated, service manual, anything.
Thanks in advance.
You need to double check the error code. That's not a valid error code listing.
Now the machine does not show any error code, it turns on and when it tries to make the copies, after it scans it stops and says "Internal Power Failure"
Any ideas what this might be? Fuser unit is new
Thanks
Clean your transfer/detack assembly or replace them,also while your at it pull in and out your blue cleaner a few times this cleans your charged scorotron. If all fails you most probably got a faulty HVPS.
But normally giving the the transfer wires a good wipe and dust of cures this fault.
Thanks for your help, I will try this on Monday and let you know about the results.
Hi! Did you fix the problem? I´ve heard talk about problems with CCD pwb. Some resistors could do a poor contact with the CCD pwb.
Look at my 4shared folder for some files.....
h**p://www.4shared.com/file/244759197/6c9f16e0/142724000.html
Hi, Thanks for your interest, I was not able to fix the machine we are still pending on that one. I tried to open the file that you told me but it said it had some error and was not possible to do it, I will appreciate it if you can send it to me again or to my email gitana1983@hotmail.com.
Thanks a lot in advance.
ops my bad... try this link.. ther are some files that could be usefull
4shared - free file sharing and storage - share folder - My 4shared
First i would replace the transfer and detack corotrons. If you still have the fault then replace your HVPS.
Bookmarks