Dear All
DCCS50 Problem - Network Controller disabled
this appears when a print is sent to printer.
thanks
Dear All
DCCS50 Problem - Network Controller disabled
this appears when a print is sent to printer.
thanks
HI! before ordering a lot of expensive parts try to reload dccs50 controller software
yeah! cobra uses a filthy software. its duty is to cause trouble and give wrong messages.
I threw my cobra rip and took in a x12 a month after install
a machine is only as good as your tech : source:screwtape ; the scary one
Please check if you are using correct printer driver. Cobra I is developed by Splash Technologies and Cobra II is from EFI. Printer drivers are not compatible to each other. If you are able to get one print and then cobra is going offline OR controller disabled, then it could be priver problem.
Ajit
Check NVM location 752-008.For Copier/Printer should be 1 and for Copier/Printer/Scanner should be 2.
There is also another NVM location you must set for Cobra,but I can't remember what it was.If I found it I'll post here
i had cobra fiery with xerox dc12
i need the controller firmware to refresh the controller
my email id is manojsaini87@gmail.com
thanks in advance
controler software or machine firmware
a machine is only as good as your tech : source:screwtape ; the scary one
have mailed you cobra installation files .
a machine is only as good as your tech : source:screwtape ; the scary one
Bookmarks