Xerox DC230 problem: network controller disabled

**Enzo** · 03-23-2010

hi friends. unexpectedly when I have turned on the car it has appeared me this error: network controller disabled. I don't succeed anymore now in printing from the computer in what the controller of net it is disabled. how to do for rehabilitating it? thanks.

**tech9** · 03-23-2010

Sorry not quite clear on what you are actually saying ? I you have a network controller fault you will need to do and Altboot first the 230's use the hyperterminal where you have to type in the commands. If it has been converted back to a DC copier i.e hard drive removed ess pugged out, then you will have to reconnect these back. Hope this helps

**Enzo** · 03-24-2010

the problem is not that to remove and reconnect the plug. I have already tried to do it but the same doesn't work! I believe is a problem of inside commands to the machine.

**suckis** · 03-27-2010

Have you got an error code to show us?

**Enzo** · 03-27-2010

is not shown any error code! the message is shown only to me that the net controller is disabled

gregoryk · 03-27-2010

pres key button then # and ten 1,1 this will direct you to the service menu check the errors and tell us what is the fault code

**Enzo** · 03-27-2010

ok thanks. I hope can resolve me this problem

**Enzo** · 03-29-2010

the codes of error are:

N5-1 POST result not reported
and
N7-11 IOT-ESS communication failure

**Silvio Ribeiro** · 05-01-2010

If etive giving flaw in the network controller and print it should show a fault code, what is this code? You will probably have to reload the software from ESS, but for this you have to have a PWS.

**Enzo** · 05-01-2010

Originally Posted by Silvio Ribeiro

If etive giving flaw in the network controller and print it should show a fault code, what is this code? You will probably have to reload the software from ESS, but for this you have to have a PWS.

the fault code is tihis: N7-11 IOT-ESS communication failure . however I have a pws. how can I reload the software?