Thanks:
0
Likes:
0
Dislikes:
0
-
Trusted Tech
50+ Posts
- Rep Power
- 0
Thanks xcopytech
how to print configuration report from machine
I have the message desplay in my machine (communications problem encountered )
-
You cannot perform software upgrade until get machine is fully operational, mean machine come to ready to copy.
If your battery on ccm pwb have 3v and you still can not get machine to working condition (connect wcps diag and perform dc 105 and dc133 as someone mentioned here before) then your ccm pwb or ccm nvm pwb is broken
-
Senior Tech
250+ Posts
- Rep Power
- 35
If you use the Altboot version of reload then it should come up. Read in the installation procedure of the manual to do the Altboot reload. The Altboot goes around the normal way of upgrading when you have a machine that won't come up ready.
-
Trusted Tech
50+ Posts
- Rep Power
- 0
DC133..JPGtHIS IS MY DC133 AND DC 105 CONFIGURATION
DC105..JPG
-
Altboot will load just controller software, not for IOT.
But think his problem is not with controller then with CCM or CCM NVM PWB or he did not follow procedure for battery replacement.
-
change both install phases to installed, set proper product type, system configuration, voltage and frequency and allow machine to restart.
if machine come to ready to copy then you can upgrade system software.
if still get dots and communication problem message try with new CCM NVM PWB or CCM PWB
-
Trusted Tech
50+ Posts
- Rep Power
- 0
Thanks xcopy
where is it CCM NVM PWB in my machine
test_..JPG
-
this small pwb with battery is CCM NVM PWB, and big one under it is CCM PWB
-
Trusted Tech
50+ Posts
- Rep Power
- 0
where is it CCM NVM PWB in the picture controller ? thanks xcopytech
-
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks