I just bought another DC12 that was locally available. This DC12 comes with a choice of an X12 or an EX12 RIP and neither seem to work.
I would obviously like to have the EX12 but when it's turned on it just beeps a few times and then either stops beeping or continues into one long beep. When I connect a monitor to it, it shows absolutely nothing. Any clues what's happening here?
The X12 is a bit more lively in that it goes through the normal boot up processes but when it gets to loading it just sits there and doesn't proceed to ready. If I try to "restore backup" the screen goes blank and it also just sits there doing nothing. Any clues on this one? I don't have the software for either but I do have a working X12 and I was wondering if cloning the hard disk on that one and putting that in the new one might be a solution?
Any help appreciated.
P.S. I've cross posted this to Xertech
Bookmarks