C3545 can help me with this error message, what do I write the serial

[tower]

Can help me with this error message, what do I write the serial

-Fault Cause: Password routine will be required to write serial number to the IOT and CCM
-Machine_Reaction: Stop all marking capability

[xcopytech]

check battery on CCMNVM PWB in controller. If voltage is bellow 2.7V replace battery and then perform dc 133 and dc 105

[tower]

What is the password routine?

[tower]

how do I synchronize the serial?
DC371 click Unique ID that I have to put password.

c2636..JPG

[pal.xerox]

try this password 2845490

[tower]

see the image
does not work
thing wrong
you can help me

id..JPG

[pal.xerox]

Please see the detail bellow and try with the password as i mentioned in my previous reply ( 2845490). if problem not resolve with this action then u hv to order new soks. gud luck

1. Reserialize machine.
   <LI id=svc.cope.0000355221>Enter the Diagnostic Mode. Refer to Entering Diagnostic Navigator.
   <LI id=svc.cope.0000304192>Select Adjustments tab
   <LI id=svc.cope.0000304195>Select Install/Cfg (DC371) tab
   <LI id=svc.cope.0000304198>Synchronize Serial Number.
   
   1. <LI id=svc.cope.0000304201>Select S/N Synch (DC132).
      <LI id=svc.cope.0000304204>Select Generate Id.
      <LI id=svc.cope.0000304207>Call service support and report Unique Machine Identifier.
   2. Enter Password from service support into Submit Password.
   3. Select Submit Password.
      Serial numbers are now synchronized.

[tower]

to have the correct password I call call service support, there is no other way.
the machine can 'operate without serialize.
thanks

[tower]

with these two files I can do something?
3116467088_AllNVM.bnf
3116467088_IOTCriticalNVM.bnf

[XFather]

The yellow battery on CCMNVM PWB is death, you need to replace and perform to procedures for replacing battery. Search in eureka for details.
You d'not need to make DC132.