It suffers from bad connection of contact film around the touch panel .
So first thing take the touch panel element off the control panel screen.
All the bellow explanation is referring only for surrounding (frame) of touch screen where the X,Y contacts are (no need and is dangerous to apply heat anywhere else )
I used heater ( in my case Heater used for desoldering IC). Apply heat on the entire length (be carefull not to melt the film, how much that's a bit tricky) and use your fingers as your gluing it.
Mostly pay attention to corner joints you should heat them up and hold them with your fingers a bit more so it can make good contact and at last the contacts of the strip that goes to connector. Shame i didn't take picture. Next time first thing with a little tutorial.
Bookmarks