Thanks:
0
Likes:
0
Dislikes:
0
-
Technician
- Rep Power
- 28
Xerox CopyCentre 123/128
I'm in the UK and have imported some Drum refurbisment kits from PartsDrop for the Xerox Copycentre 123/8. The kits initially work fine but after about 250 copies copyquality fades completely.
Has anybody had any problems with these kits and does anybody know where the Xerox OEM drum 13R00589 can be purchased at a reasonable price. They are £150 in the UK and are hard to get hold of - even at this high price
Thanks to you all
-
Field Supervisor
500+ Posts
- Rep Power
- 37
-
Senior Tech
100+ Posts
- Rep Power
- 30
Sounds like a development issue. Will do a little digging and get back to you.
Glenn
-
Senior Tech
100+ Posts
- Rep Power
- 30
Mr. Keyboard - Not sure what is happening - 123 must think it's toned but it isn't. Are you vacuuming the adc sensor? - a no no. Are you sure the augers are turning? The problem is probably not the kit - more likely a slip in the rebuild process - is the developer bias clip in place and rebent to contact the dev roll good at the flat spot (determines magnet angle)? We filter the dev because it is loaded with crapola and causes line deletions. And we replace the pcr roll and blade.
Hey Mr. Allen - HowdIdo? IfanybodybelievesthisIhaveabridgetosell!
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks