WorkCentre 5645 03-XXX error

[livewire]

Hi everybody,


I have a little problem with WorkCentre 5645 copier only.

See attachment file to view Fault History Report.

The error codes are:

03-350 The IOT has detected no response from the tray 1 and 2 control PWB to the ping request.
03-315 The image processing PWB has performed a crash recovery procedure.
03-300 The image processing PWB to IOT communications have failed.
08-151 The trail edge of the paper was late to the registration sensor after the registration clutch, CL08-070 on.
03-371 The fuser CRUM communications have failed.
03-372 The xerographics CRUM communications have failed.

This is a very strange problem.

Todey a was made only few copies from tray 1 (A4SEF), tray 3 and tray 4 (A4LEF).

I have paper jam at area 1, 3 and 4.

Any supposition?

Thank you.

[adriansto]

Seat and reseat the xerographic and fuser modules. Clean the transfer/ detack assy and try again to make copies. First of all power off the machine.

[livewire]

Hi everybody,
the case is done.
thank you to adriansto to respond.
There is a short circuit on yellow cable between (PJ142 pin1) Main drive PWB and Xerographic module CRUM.
See attachment pictures.
1.jpg 2.jpg 3.jpg
Sorry for low quality.

Cheers!

[chand226]

what happened after short circuit ?

Hi everybody,
the case is done.
thank you to adriansto to respond.
There is a short circuit on yellow cable between (PJ142 pin1) Main drive PWB and Xerographic module CRUM.
See attachment pictures.
1.jpg 2.jpg 3.jpg
Sorry for low quality.

Cheers!