It can be caused from BGM drawer problem, not latching properly check here download both pdf files DC5000 warming up
Or by this connector (red circle) replace ALL the wires that goes to 2ndBTR drawer.jpg
Good luck.
Some time ago I had a 2nd BTR retract fail issue on my 2060, I discovered that when I closed the drawer and after turning the handle to lock the drawer and folding the handle up and could turn it a further little bit ccw so that the handle stayed up, this last little turn caused the failure and when I didn't do the last bit I didn't have the issue.
Thank you friends for your support so far. I am highly impressed by your response so far.When I followed your comments I discovered that the -[handle shaft gear (P/N 7E55160)] is broken. And fromevery indication It wil have tobe replaced. Please where can I get one to buy?
Thank you all for your assistance in my xerox dc 2060 so far. The BTR retract fail was due to a broken gear (7E53480) I surppose. Now in my attempt to replace the gear, the center pulley for the AREA 4 HANDLE Removes and it has been difficult to do the fixing. PLEASE I NEED YOUR HELP for solution
Thank you all for your assistance in my xerox dc 2060 so far.The BTR retract fail was due to a broken gear (7E53480) I surppose. Now in my attempt to replace the gear, the center pulley for the AREA 4 HANDLE Removes and it has been difficult to do the fixing.PLEASE I NEED YOUR HELP for solution on the diagram (image) of how the pulley is to be fixed
Bookmarks