Xerox 5252 error code list

[erdiwaz]

I have error code 003-379 on my xerox 5252 and 010-367.
Can anyone help me please?
Is it possible to error code list for this model?

Thanks

[GusG]

I have error code 003-379 on my xerox 5252 and 010-367.
Can anyone help me please?
Is it possible to error code list for this model?

Thanks

I am assuming that the error codes for a 5252 are the same as for a 2060, someone please correct me if I'm wrong. If that's the case:

3-379 Dongle Broken

10-367 Heat Roll Overheat Fail

Attached is a list of some (not all) error codes for the 2060

[erdiwaz]

I am assuming that the error codes for a 5252 are the same as for a 2060, someone please correct me if I'm wrong. If that's the case:

3-379 Dongle Broken

10-367 Heat Roll Overheat Fail

Attached is a list of some (not all) error codes for the 2060

Thanks a lot, I will check and tell if goes well.

Thanks again...

[iguano]

I have error code 003-379 on my xerox 5252 and 010-367.
Can anyone help me please?
Is it possible to error code list for this model?

Thanks

We also hawe same problem with 010-367 on dc5252.
Did you hawe some solutions?
How to reset error?
Thanks

[tasosGR]

We also hawe same problem with 010-367 on dc5252.
Did you hawe some solutions?
How to reset error?
Thanks

NVM location 744-016, Heat Roll Over Heat Fail 2 is reset to 0

[xtrain]

Thanks a lot, I will check and tell if goes well.

Thanks again...

Are you familiar with the dongle? It is a chip installed on the system PWB at location P646, and it determines the speed,45,52,60 prints per minute. It must match the IOT software, which in your case is 5252. To access the dongle, you must remove the system PWB, which is quite a job if you are not experienced on this product. The communication cable from the system PWB to the IOT PWB might be disconnected or damaged. Good luck.