In DC 12 One side light copy is coming... I tried Single color copy in cmyk the bottom side is coming light and the top side is good. Please let me know the problem...
thanks in advance
dc 12.jpg
In DC 12 One side light copy is coming... I tried Single color copy in cmyk the bottom side is coming light and the top side is good. Please let me know the problem...
thanks in advance
dc 12.jpg
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
I presume that's an A4 printed LEF so that the problem is inboard to outboard? If that's the case you may just need to do a nip adjustment of the fuser by the looks of your print. Otherwise do a max setup and see what happens, could also be dirt in the ROS or other things but try the NIP adjustment first.
Yes, first of all clean optics and charge corona assy, then run Max Setup.
Hi, the other thing that I will do is a panic stop, print some document and wend you have one on the output tray just open the front door and look at the print before the fuser. Is the defect is on the print your problem is related to optic, drum, dev or any other before fusing. Is there no problem or the print look even then is your fuser.
MR
Do max setup and check the dev bias adjustments. (top part of the IOT highlight adj routine) the values should normally be at 128 for each dev assy.. Lower/raise the number in each color to increase/decrease the dev bias voltage to match the inboard part of the test pattern that is printed. Don't go lower than 98 or higher than 158 in each color. If you still have a problem check the charge screen on the drum assy and try cleaning.
Bookmarks