Xerox Diagnostic software

[Enzo]

Strange but ok
For ESS you need serial null modem cable, minicentronics paralell cable and altboot with software version for ESS.

I could get pictures of the cables required?

[adriansto]

I could get pictures of the cables required?

Tell me your email.
I'll make a picture right now

[Enzo]

Your 300 and 600 values are ok but the in /out values are waay too high. Start all the in/out values at 128 then lower/raise by 5 points each to adjust the machine front edge of the test pattern that prints out to the rear machine edge of the test pattern

With these values ​​the copy comes out too green! how can I set the machine to get a perfect copy? What are the best values​​?

[adriansto]

Must do complete MAX SETUP series like is manual explains !

[Enzo]

Must do complete MAX SETUP series like is manual explains !

I do not have the manual. I am going to attempt!

[walidcharifi]

hello
someone tells me how does the firmware update for C2128

[Assal3D]

Yeah, I want the PWS software too. Xerox says "it's propriatary", but they'll sell it to me for $3500, plus an annual renewal fee of $800 per year. Whatever. Still looking for some sort of solution for the problem. Need to get into a DC470's rip with it.

well I've PWS supporting lot of xerox copiers versions for only 1800 $ if you like

[SEnder]

470 st, Lakes. You can connect controller with serial crossover cable using hyper terminal.
For this you dont need PWS.
I have two spare controllers for 460st and 480st.

[Enzo]

Hello friends. I have a problem with Xerox DC12. The print is too red! What are the correct values ​​to get a good print?



Uploaded with ImageShack.us

I have left the problem of light gray that is printed in yellow! How can I fix it? What settings should I set the machine in diagnostics? thank you very much

[SEnder]

Reduce bias for Y to 256 both 300 and 600 lines. Calibrate your Fiery or Splash..whatever