Hi group, I have a workcentre C35 giving a fault code 14-110 "scanner needs service". Any ideas? Thanks.
Hi group, I have a workcentre C35 giving a fault code 14-110 "scanner needs service". Any ideas? Thanks.
There is a fault with CCD PWD.On the upper right corner of this board you can see that it has burned.I usually replace SMD Resistor with 131ohm mark on it and it works for a while.
Last edited by bojans; 08-11-2012 at 09:24 PM.
i have that problem too. when scanner come to end its stuck and knock knocked..
there is the picture inside of ccd
photo1.jpgphoto2.jpgphoto3.jpg
how can i config CCD bord ?
look at the flashes
aas.jpg
Hi,
you need to replace the ccd pwb with a new one. It has better resistors on it. Make sure you shim the old one as that is the only way to be sure of getting the new ccd pwb in the correct position.
Bookmarks