scanner for 510 wide format

[walidcharifi]

hi
my scanner Synergix wide format
when I put the paper to make a copy * ll-47 *
and * width detection failed pleas entre width of centre-registred document *
i entre width 914mm
- the whole page is black

[technogeek2009]

Looks like you are going to need a manual for the scanner, and do some diagnostic work. Below is what the manual recommends for the LL-47 error code. However, black image is yet another problem, separate from the LL-47 error. I would try re-seating all the connectors going to the main board, as well as the image processing board atop the main board.

LL - 47
Gain calibration failure on Channel 1. (Dark streaks).
NOTE:
LL-47 displayed only momentarily on Scanner Control Panel.

Examine the Calibration Target Strip, the SelfFoc Lens, and the Platen Glass for dirt or contamination; clean if required. Use the Calibration Motor test in Scanner Diagnostics to rotate the Calibration Extrusion and gain access to the target strip.

Replace the Lamp [REP 6.4 Exposure Lamp], particularly if the lamp has discoloration at the ends.
Go to the Scanner Diagnostics and do the Full System Test. Troubleshoot any failures. Do the Scan Bar Calibration Test. Troubleshoot any failures.

If the problem still exists,
replace the Scanner Main PWB [REP 3.1 Main PWB]. If the problem still exists, replace the Image Module [REP 9.2 Image Module].
BSD 6.2 Image Capture
PL 1.4 Electrical Module
PL 1.3A Image Module and Document Feed Rollers (Part 1 of 2)

[walidcharifi]

Looks like you are going to need a manual for the scanner, and do some diagnostic work. Below is what the manual recommends for the LL-47 error code. However, black image is yet another problem, separate from the LL-47 error. I would try re-seating all the connectors going to the main board, as well as the image processing board atop the main board.

LL - 47
Gain calibration failure on Channel 1. (Dark streaks).
NOTE:
LL-47 displayed only momentarily on Scanner Control Panel.

Examine the Calibration Target Strip, the SelfFoc Lens, and the Platen Glass for dirt or contamination; clean if required. Use the Calibration Motor test in Scanner Diagnostics to rotate the Calibration Extrusion and gain access to the target strip.

Replace the Lamp [REP 6.4 Exposure Lamp], particularly if the lamp has discoloration at the ends.
Go to the Scanner Diagnostics and do the Full System Test. Troubleshoot any failures. Do the Scan Bar Calibration Test. Troubleshoot any failures.

If the problem still exists,
replace the Scanner Main PWB [REP 3.1 Main PWB]. If the problem still exists, replace the Image Module [REP 9.2 Image Module].
BSD 6.2 Image Capture
PL 1.4 Electrical Module
PL 1.3A Image Module and Document Feed Rollers (Part 1 of 2)

the Calibration Motor test in Scanner Diagnostics to rotate the Calibration Extrusion and gain access to the target strip.


fine

[epsylon]

sorry anybody have the part number of the exposure lamp

[technogeek2009]

We stock this part 122E02640 $258 plus shipping.