service manual need how to go into wcpro 35 service mode

[pc123321]

where can i download wc pro 35 service manual
thanks

[adriansto]

where can i download wc pro 35 service manual
thanks

I have it but in edoc format.

[bojans]

where can i download wc pro 35 service manual
thanks

Why do you need to go into service mode?

[pc123321]

Why do you need to go into service mode?

yes to see
to clear the message replace waste toner box

[seansbar]

you don't need service mode. Empty the bottle and make sure there is no residual toner in the area were the sensor "sees"

[pc123321]

Why do you need to go into service mode?

yes to see
to clear the message replace waste toner box

[pc123321]

yes to see
to clear the message replace waste toner box

i try two new clean unused well pack box ,inside waste toner box , give me the same message ,
yesterday i try once disassembly the power unit and put it back ,test ,give me the same message ,
tomorrow i try again
the whole unit gear transfer i took out before ,there are two small screw fasten to the sensor frame (left side white plastic sensor cover)
sensor frame position will change ,it depend on two alignment screw holes

[bojans]

Check PM!

[pc123321]

Check PM!

the waste toner box door switch , i used wire to short circuit then the screen message only replace toner box
the fault error code 09-380 disappear , but the screen message is replace waste toner box 03-700,03-785 only power
to continue check out ----tomorrow reseated the waster toner box switch

[efe311]

where can i download wc pro 35 service manual
thanks

# & key password is 1943

& make initial its work
i make it many times