be sure to set the nvm location 741-105 to zero. make sure the patch and sensor are clean. vacuum out the cleaning blade.. get all that toner out of there. dust the blade and put it back on trying to center it. fire it up. do the adjustment and you should be good. if not. then try that patch deal.. i havent done it. i just would try a new belt.
Hi. I've the same error code (042-326) - xerox dc240.
I cleaned everything I could to clear. Silver stripe looks clean - but it aren't changed.
Error of course remains, 741-105 change to 0 has no effect.
Because I moved belt I also tried to do learning cycle - the message is 'diagnostic routine error'.
Change, however, a silver stripe?
First of all check the belt is moving.
When I turn on machine I can hear that machine starts to work but at some point the machine stops rapidly.
When I turn the mode of learning for the belt there is no response from the machine.
Does anyone have a photo on which it is a 'silver strip sensor'?
When you reinstall the belt, make sure the silver reflective patch is to the rear of the machine. The sensor has to "look" at the patch as it passes by it so it should not be hard to locate the sensors "eyes" in the patches's path. A lot of times you can get away with cleaning , putting on a replacement patch, installing an anti-curl kit. But sometimes you just need to install a new belt. If you install a new belt, the patch has a clear plastic layer over the reflective patch. Sometimes the sensor can see the patch through this and sometimes not. I always remove this from the patch when installing a new belt.
Hi
Similar problem hapened to me a couple years ago on my 250
The Solution was cleaning the sensor of the belt edge learn, on the ibt module, mine had black toner on it (sensor) and the machine was always giving the error.
A very good clean with careful and it was done.
Hope it helps
cheers
Bookmarks